eric@ericwelchpainting.com
This form does not yet contain any fields.
    Contact Info

    1341 Spaight St.

    Madison, WI 53703

    eric@ericwelchpainting.com

    Testimonials

     

    Entries in exterior painting (2)

    Monday
    Mar192012

    When to spray a house?

    When to spray a house? We use a sprayer to apply primer and top coat when the surface area of the siding is large enough to justify the extra cost in paint and preparation. If the side of a home is mostly a continuous expanse of siding then the decision is easy to make. If there are lots of different colors or trim that is not being painted or brick and stone, then chances are spraying wont be the most effective way to accomplish the job. We spray when we can because it is typically more efficient then brushing or rolling and applies paint to a mil specificity. Spraying lays the paint on very smooth, smooth and thick. By spraying we are able to lower the labor rate and apply the paint faster. To sum it up: higher paint cost, lower labor cost.

    Sprayed or brushed it is recommended that one coat of paint be used when the new paint color matches the old, and that two coats of paint are used when there is a color change or the substrate (wood or vinyl) is in bad condition. The first coat protects the house and the second coat protects the first. Whether one or two coats, a primer coat is applied first. Spraying applies the paint very fast and even.  These advantages are suited ideally for vinyl and aluminum siding and gives the siding a near “factory finish.”

    *Interiors can be sprayed as well

    Method: We’ll tape off any windows and doors and lay tarps over all surfaces under and around he area that is going to get painted by sprayer. If needed, we will ask that cars be moved but generally we do not spray on windy days. Windows, trim, door frames and fascias are all generally brushed by hand. We use only Purdy or Wooster brand brushes, most professional painters use these brushes and I suggest you do too if and when you choose to paint. A good brush makes a world of difference.

    After the first coat is a good time to check over the house one more time. Apply additional caulk if a gap is spotted or put on another coat of wood filler to the woodpecker holes. Then, the second coat. This is where the colors really come out and smooth finish of the paint looks its best. Remember, the second coat protects the first coat that protects the house. It’s all about protecting the home from the elements, increasing its value and making it look great at the same time. Tape is pulled as soon as the paint begins to dry. All tape, paper and plastic is disposed of and removed from the premise.

    A final check through and walk-around with the homeowner. We’re not done until the homeowner is satisfied. In other words, we don’t get paid until you’re happy. On top of a complete satisfaction guarantee, we offer a top of the line three-year workmanship guarantee as well.

    Monday
    Mar192012

    What does it take to paint the exterior of your home? 

    Everything you need to know about painting your exterior and tips from Eric Welch Painting.

    Residential Exterior
    A contractor needs to be Lead-Safe certified to work on a house with peeling paint if the house was built prior to 1978 (the year lead based paint was banned for residential use.) It is possible to take a sample to the Wisconsin Department of Health Services and test it for lead paint. This usually takes about seven days and costs about $50 dollars. If a paint sample is not tested then it is assumed that lead is present and all necessary precautions must be taken.

    Before any prep begins my Madison painters lay plastic and secure it to the ground so it will not blow around. A painter must wear a protective face mask that guards against dangerous particulates and is taught how to stay clean and avoid accidental ingestion of lead dust. Fortunately, the are only two ways lead can enter the body and cause any harm, one is through the mouth and the other is through the nose. Simple right? Yes, but it is very important to be safe as lead contaminates build up in the body’s fat tissue and can effect the brain, especially in children.


    Proper preparation often times amounts to many tedious and meticulous hours of scraping. It is the least fun and most important part of every paint job. Hit every angle and take care to go over each area twice. Power-washing of most exteriors that have peeling paint is now not allowed due to the restrictions put in place by the EPA. Power-washing is still useful where the previous paint is still sound and on any house with vinyl or aluminum siding. We will use a power-washer when it is necessary and within the law. Any areas that have mold and mildew, use a bleach/ water mixture of 1 part bleach to 3 parts water. Use sponge or brush to apply or a pump spray canister (easiest method.) 

    Cleanliness. We clean up around the house and check to make sure all the surfaces have been thoroughly prepped. Then we dispose of the plastic and haul it away from the job site. Rejoice! The prep is done.

    Once the preparation is complete, it’s time to apply the primer. Typically this is done with a brush and by hand. Windows and door frames are almost always primed and painted with a brush but primer will be sprayed if the surface area of the siding is large enough to allow for efficient use. As a side note, high-end, A+ paints often have primer built in to them, aka 2 in 1s. This does not render primer less necessary it just adds to the benefits.

    The Final Paint or The Top Coat. The body color will most likely be applied first. If we brush and roll the siding then there will be very little plastic or tape used. Tarps will be laid around the house to cover any concrete and on top of shingles. No Drips. Period. Whether we are painting wood, vinyl, aluminum, clapboard, asbestos, asphalt, composite, brick or stucco, we can paint it and it will last.

    We miss nothing. The details are what make an excellent paint job. If you’ve ever been unhappy about a previous painter it is probably because of one or more of the following issues. 1.) didn’t prep right and new paint job is now starting to fail. 2) Paint was not applied in a clean manner, lines are not straight, drips are on the concrete or other woodwork. 3.) The details were neglected. We always focus on the details. The soffits, the facsias, behind the downspouts, the hard to reach places, the very high places and we take the time needed to make them look great. Oh, and those little windows down near the foundation that are half covered by dirt, we get those too.

    Eric Welch Painting is the best choice for painters in Madison.